Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Small EVAP Rear Pipe Quick Connect Fittings

Courtesy of GENERAL MOTORS CORP.

Position and connect the small EVAP rear pipe quick connect fittings to the rollover valve and the fuel tank module. Refer to Plastic Collar Quick Connect Fitting Service .

Fig 2: Locating Fuel Tank Clips

Courtesy of GENERAL MOTORS CORP.

Position and connect the EVAP rear pipe quick connect fittings to the rollover valve and the fuel tank module. Refer to Plastic Collar Quick Connect Fitting Service .
Install the EVAP rear pipe to the fuel tank clips (1 and 2).

Fig 3: Locating Fuel Tank Clip

Courtesy of GENERAL MOTORS CORP.

Install the EVAP canister purge pipe to the fuel tank clip (1).
Install the fuel tank. Refer to Fuel Tank Replacement .