LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1604 (Engine Control System & Fuel System - Hybrid (Hp2) 6.0L (LZ1) - Repair Instructions) >> Repair Instructions >> Auxiliary Evaporative Emission Canister Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Clean the evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting the fittings in order to avoid possible EVAP system contamination.
    Fig 1: Locating Quick Connect Fittings
    GM1964762Courtesy of GENERAL MOTORS CORP.
  1. Remove the EVAP canister vent solenoid valve. Refer to Evaporative Emission Canister Vent Solenoid Valve Replacement .
  2. Disconnect the EVAP pipe quick connect fitting (3) from the auxiliary EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
    3. Fig 2: View Of Auxiliary EVAP Canister Nuts
    GM1965655Courtesy of GENERAL MOTORS CORP.
  3. Remove the auxiliary EVAP canister nuts (1).
    4. Fig 3: View Of Auxiliary EVAP Canister
    GM1965658Courtesy of GENERAL MOTORS CORP.
  4. Remove the auxiliary EVAP canister (1) from the vehicle.
scientia non olet · About LEMON Manuals