LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1579 (Seat Heating System & Seat Cooling System) >> Diagnostic Information and Procedures >> DTC B2435 or B2440 (Dealer Installed) >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

B2435 02 or B2435 05

  1. Ignition OFF, disconnect the X2, X4 harness connectors at the HSM.
  2. Test for 850 Ω - 300 kΩ between the signal circuit terminal 19 X4 and the low reference circuit terminal 5 X2.
    • If less than the specified range, test for a short between the signal and low reference circuits. If the circuits test normal, replace the seat back heater element/temperature sensor.
    • If greater than the specified range, test the signal and low reference circuits for a short to voltage or an open/high resistance. If the circuits test normal, replace the seat back heater element/temperature sensor.
  3. Connect the X2, X4 harness connectors at the HSM.
  4. Disconnect the harness connector at the seat back heater element/temperature sensor.
  5. Ignition ON, test for 4.8 - 5.2 V between the signal circuit terminal C and ground.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the HSM.
    • If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the HSM.
  6. If all circuits test normal, replace the HSM.

B2440 02 or B2440 05

  1. Ignition OFF, disconnect the X2, X4 harness connectors at the HSM.
  2. Test for 850 Ω - 300 kΩ between the signal circuit terminal 10 X4 and the low reference circuit terminal 7 X2.
    • If less than the specified range, test for a short between the signal and low reference circuits. If the circuits test normal, replace the seat back heater element/temperature sensor.
    • If greater than the specified range, test the signal and low reference circuits for a short to voltage or an open/high resistance. If the circuits test normal, replace the seat back heater element/temperature sensor.
  3. Connect the X2, X4 harness connectors at the HSM.
  4. Disconnect the harness connector at the seat back heater element/temperature sensor.
  5. Ignition ON, test for 4.8 - 5.2 V between the signal circuit terminal C and ground.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the HSM.
    • If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the HSM.
  6. If all circuits test normal, replace the HSM.
scientia non olet · About LEMON Manuals