Circuit/System Testing

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Ensure the transmission fluid temperature is between 50-80°C (122-176°F).
Operate the vehicle in 2nd gear long enough to ensure at least a 3°C (5°F) rise in TCM temperature.
Place the gear selector in Reverse for 5 seconds and then idle vehicle for 5 seconds.
Observe the scan tool data parameter Shift Sol. 1 CKT Status. The parameter should display OK.
- If the parameter displays Open, Short to Volts, Short to GND, or if the DTC resets, perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection .
- If no concerns are found during the inspection, replace the control solenoid (w/body and TCM) valve assembly.