LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1356 (Automatic Transmission - 4L60-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Oil Pump Cover and Body Assemble >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra and 2009 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pump Cover, Oil Pump Body & Bolts
    GM1552936Courtesy of GENERAL MOTORS CORP.
  1. Place the oil pump cover onto the oil pump body and put stator shaft through a hole in the bench.
  2. Install the pump cover bolts (233) finger tight only.
    3. Fig 2: Identifying Pump Cover Bolts
    GM1552965Courtesy of GENERAL MOTORS CORP.
  3. Install the J 21368:  alignment band.
    4. CAUTION: Refer to Fastener Caution .
  4. Tighten the pump cover bolts (233). Tighten the bolts to 24 N.m (18 lb ft).
  5. Remove the J 21368:  alignment band.
scientia non olet · About LEMON Manuals