Removal Procedure
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
In order to equalize wear, rotate the tires at the specified intervals. Refer to Maintenance Schedule (North American Emissions) . In addition to scheduled rotation, rotate the tire and wheel assemblies whenever you notice uneven tire wear.
Radial tires tend to wear faster in the shoulder area, particularly in front positions, due to design. Radial tires in non-drive locations may develop an irregular wear pattern that can generate tire noise. This especially makes regular tire rotation necessary.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the center caps from the vehicle, if equipped.
- Remove the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
- For vehicles with single rear tires (4 tires), rotate the tires as shown.
- For vehicles with single rear wheels (5 tires), rotate the tires as shown.
- For vehicles with dual rear wheels, same tire sizes and load ranges, rotate the tires as shown.
- For vehicles with dual rear wheels, different tire sizes and load ranges, rotate the tires as shown.
- For vehicles with dual rear wheels, including the spare tire, rotate the tires as shown.