LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1306 (Fixed & MOVEABLE Window System) >> Diagnostic Information and Procedures >> Power Rear Sliding Window Malfunction >> Component Testing >> Relay Test

Relay Test

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the appropriate relay.
  2. Test for 60-200 ohms between terminals 85 and 86.
    • If not within the specified range, replace the relay.
  3. Test for infinite resistance between the following terminals:
    • 30 and 86
    • 30 and 87
    • 30 and 85
    • 85 and 87
    • If not the specified value, replace the relay.
  4. Test for less than 2 ohms between terminals 30 and 87A.
    • If greater than the specified range, replace the relay.
  5. Install a 3-amp fused jumper wire between relay terminal 85 and 12 volts. Install a jumper wire between relay terminal 86 and ground. Test for less than 2 ohms of resistance between terminals 30 and 87.
    • If greater than the specified range, replace the relay.
scientia non olet · About LEMON Manuals