LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1161 (Manual Transmission - AISIN AY6) >> Repair Instructions - On Vehicle >> Transmission Replacement >> Transmission Final Test and Inspection

Transmission Final Test and Inspection

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Complete the following procedure after the transmission is installed in the vehicle:

  1. With the ignition OFF or disconnected and clutch pedal depressed, crank the engine several times. Listen for any unusual noises or evidence that any parts are binding.
  2. Place transmission in neutral, start the engine and listen for any unusual noises or evidence that any parts are binding.
  3. While the engine continues to idle raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Perform a final inspection for the proper fluid level. Refer to Transmission Fluid Level Inspection .
  5. Lower the vehicle.
  6. Road test the vehicle.
scientia non olet · About LEMON Manuals