LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1139 (Engine Controls And Fuel - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Intake >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Right CMP Actuator Valve Electrical Connector - Intake
    GM1285235Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition OFF.
  2. Remove the front compartment sight shields as necessary. Refer to Front Compartment Sight Shields Replacement .
  3. Disconnect the camshaft position (CMP) actuator valve electrical connector.
    4. Fig 2: View Of Right CMP Actuator Valve - Intake
    GM1285237Courtesy of GENERAL MOTORS CORP.
  4. Remove the CMP actuator valve bolt.
  5. Remove the CMP actuator valve.
  6. Inspect the CMP actuator valve seal for damage. Replace the seal if necessary.
scientia non olet · About LEMON Manuals