LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1138 (Engine Cooling System) >> Repair Instructions >> Water Pump Replacement (LY7, LLT) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Water Pump
    GM946142Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW water pump seal.
  2. Install the water pump.
    3. NOTE: Refer to Fastener Notice .
  3. Install the water pump bolts.

    Tighten:  Tighten the water pump bolts to 10 N.m (89 lb in).

    4. Fig 2: View Of Water Pump Pulley
    GM902876Courtesy of GENERAL MOTORS CORP.
  4. Install the water pump pulley and the water pump pulley bolts.
    5. Fig 3: Securing Water Pump Pulley With EN 46104
    GM1342893Courtesy of GENERAL MOTORS CORP.
  5. Use the EN 46104  (1) in order to retain the water pump pulley. See Special Tools .
  6. Install the water pump pulley bolts.

    Tighten:  Tighten the water pump pulley bolts to 12 N.m (106 lb in).

  7. Install the generator drive belt. Refer to Water Pump and Generator Belt Replacement .
  8. Fill the cooling system. Refer to Cooling System Draining and Filling (GE 47716)  or Cooling System Draining and Filling (Static Fill) .
scientia non olet · About LEMON Manuals