Transmission Oil Cooler-Three Fan System
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The transmission oil cooler system uses quick connect fittings throughout the system. Use a special tool to disconnect these quick connect fittings. Removing the transmission oil cooler lines without this tool will result in damage to the radiator, the transmission, and the transmission oil cooler caused by mixing the transmission oil and coolant or due to transmission oil loss.
There are two transmission oil coolers in a series in the heavy duty transmission oil cooler system. The initial transmission oil cooler is a heat exchanger located in the bottom tank of the radiator. The transmission oil temperature is partially regulated by the temperature of the coolant leaving the radiator and passing over the heat exchanger. Lines from the transmission bring oil pumped at a high pressure to the cooler. The oil out of the cooler is plumbed to an air-to-oil cooler in front of the A/C condenser. This cooler provides additional cooling for heavy duty trailering. The transmission oil is then directed back to the transmission.