LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1137 (Wheel Drive Shafts) >> Repair Instructions >> Front Wheel Drive Shaft Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Wheel Drive Shaft Retaining Ring
    GM1957674Courtesy of GENERAL MOTORS CORP.
  1. Install the new O-ring (2) on the intermediate shaft.
  2. Install the new retaining ring (1) on the intermediate shaft.
  3. Apply a small amount of grease GM P/N 01051344 (Canadian P/N 993037) or equivalent to the intermediate wheel drive shaft splines.
  4. Install the left front wheel drive shaft inn the intermediate shaft.
  5. To ensure that the wheel drive shaft is installed properly, grasp the inner tripod housing and pulling it outward. DO NOT pull on the axle shaft.
  6. Install the wheel drive shaft in the front knuckle.
  7. Install the left upper ball joint into the steering knuckle. Refer to Shock Absorber and Spring Assembly Replacement .
    8. Fig 2: View Of Wheel Drive Shaft Spindle Nut & Punch
    GM926765Courtesy of GENERAL MOTORS CORP.
  8. Insert a drift or punch (1) into the rotor and against the caliper mounting bracket in order to prevent the hub and bearing from turning.
    9. Fig 3: View of Wheel Drive Shaft Nut
    GM1945639Courtesy of GENERAL MOTORS CORP.
  9. Using hand tools, tighten the NEW wheel drive shaft nut until the wheel drive shaft is fully seated in the wheel hub/bearing assembly.
    10. NOTE: Refer to Fastener Notice .
  10. Tighten the wheel drive shaft nut.

    Tighten:  Tighten the wheel drive shaft nut to 160 N.m (118 lb ft).

  11. Remove the drift or punch from the brake rotor.
  12. Install the wheel speed sensor. Refer to Front Wheel Speed Sensor Replacement (RWD) or Front Wheel Speed Sensor Replacement (AWD) .
  13. Install the left outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement (with Rear Wheel Drive) or Steering Linkage Outer Tie Rod Replacement (with All Wheel Drive) .
  14. Install the left front tire and wheel. Refer to Tire and Wheel Removal and Installation .
  15. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals