LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1117 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement (RWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Stabilizer Shaft Mounting Bolts And Brackets
    GM742989Courtesy of GENERAL MOTORS CORP.
  1. Install the stabilizer shaft insulators (3) to the stabilizer shaft with the slit facing rearward.
    2. NOTE: Refer to Fastener Notice .
  2. Install the stabilizer shaft bracket (2) and mounting bolts (1).

    Tighten:  Tighten the bolts to 65 N.m (48 lb ft).

  3. Lower the vehicle.
scientia non olet · About LEMON Manuals