LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1117 (Front Suspension System) >> Repair Instructions >> Front Wheel Bearing and Hub Replacement (AWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
    3. IMPORTANT: The following service procedure is for those vehicles that are equipped with All Wheel Drive (AWD).
  3. Remove the wheel driveshaft nut and discard. Refer to Front Wheel Drive Shaft Replacement - Left Side .
  4. Remove the front brake rotor. Refer to Front Brake Rotor Replacement (RWD) or Front Brake Rotor Replacement (AWD) .
  5. Remove the wheel speed sensor. Refer to Front Wheel Speed Sensor Replacement (RWD) or Front Wheel Speed Sensor Replacement (AWD) .
    6. Fig 1: View Of Wheel Bearing/Hub Mounting Bolts
    GM904629Courtesy of GENERAL MOTORS CORP.
    NOTE: Avoid tool contact to the outer constant velocity boot seal when removing the wheel bearing mounting bolts. Failure to observe this notice may result in damage to the CV boot.
  6. Carefully remove the wheel bearing/hub mounting bolts.
    7. Fig 2: View Of J 45859 Installed Onto Wheel Hub
    GM899220Courtesy of GENERAL MOTORS CORP.
  7. Using the J 45859  , remove the wheel driveshaft from the wheel bearing/hub.
  8. Remove the wheel bearing/hub assembly.
scientia non olet · About LEMON Manuals