Rear Side Door Window Regulator Motor Replacement

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Side Door Window Regulator Motor Replacement

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement . Remove the rear side door window regulator. Refer to Rear Side Door Window Regulator Replacement .
1	Rear Side Door Window Regulator Motor Bolts (Qty: 3) NOTE: Refer to Fastener Notice . Procedure Using the power window switch, lower the window regulator about 1/2 way down. Disconnect the electrical connector from the power window motor. Tighten: Tighten the bolt (1,2,3) to 9 N.m (80 lb in).
2	Rear Side Door Window Regulator Motor Procedure The bolts are located on the back side of the window regulator. Remove the tape from the window. Start the vehicle to ensure maximum power to the window motor. This is required to fully seat the window for adjustment.

Callout

Component Name

Preliminary Procedure

Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement .
Remove the rear side door window regulator. Refer to Rear Side Door Window Regulator Replacement .

Rear Side Door Window Regulator Motor Bolts (Qty: 3)

NOTE: Refer to Fastener Notice .

Procedure

Using the power window switch, lower the window regulator about 1/2 way down.
Disconnect the electrical connector from the power window motor.

Tighten: Tighten the bolt (1,2,3) to 9 N.m (80 lb in).

Rear Side Door Window Regulator Motor

Procedure

The bolts are located on the back side of the window regulator.
Remove the tape from the window.
Start the vehicle to ensure maximum power to the window motor. This is required to fully seat the window for adjustment.