Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Generator Bracket Retaining Bolts & Bracket

Courtesy of GENERAL MOTORS CORP.

Install the generator bracket.

NOTE: Refer to Fastener Notice .

Install the generator bracket bolts.
Tighten: Tighten the bolts in the sequence shown.
1. Tighten the generator bracket bolts (1, 2) to 50 N.m (37 lb ft).
2. Tighten the generator bracket bolt (3) to 23 N.m (17 lb ft).
Install the belt tensioner. Refer to Water Pump and Generator Belt Tensioner Replacement .
Install the coolant inlet pipe lower bolt from the generator bracket.
Install the generator. Refer to Generator Replacement (LY7) .