LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1109 (Power Steering System) >> Repair Instructions >> Steering Linkage Outer Tie Rod Replacement (with All Wheel Drive) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Outer Tie Rod
    GM687434Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Install the steering linkage outer tie rod the same number of complete turns needed to remove it.
  1. Install the steering linkage outer tie rod (2) to the steering linkage inner tie rod (3).
  2. Tighten the new steering linkage inner tie rod nut (1).
    3. Fig 2: View Of Tie Rod Retaining Nut
    GM687432Courtesy of GENERAL MOTORS CORP.
  3. Connect the steering linkage inner tie rod to the steering knuckle.
    4. NOTE: Refer to Fastener Notice .
  4. Install the new steering linkage outer tie rod nut.

    Tighten:  Tighten the nut to 57 N.m (42 lb ft).

  5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  6. Adjust the front toe. refer to Front Toe Adjustment .
scientia non olet · About LEMON Manuals