LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1109 (Power Steering System) >> Repair Instructions >> Power Steering Pump Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front air deflector. Refer to Front Air Deflector Replacement .
  2. Place drain pans under the vehicle as needed.
  3. Remove as much power steering fluid from the remote power steering fluid reservoir as possible.
  4. Remove the power steering pump pulley. Refer to Power Steering Pump Pulley Replacement .
    5. Fig 1: Identifying Power Steering Reservoir Outlet Hose
    GM1300041Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the power steering fluid reservoir outlet hose from the power steering pump.
    6. Fig 2: View Of Power Steering Gear Inlet Hose & Power Steering Pump
    GM1304375Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the power steering gear inlet hose fitting from the power steering pump.
    7. Fig 3: View Of Power Steering Bracket Bolts
    GM888286Courtesy of GENERAL MOTORS CORP.
  7. Remove the power steering pump bracket bolts.
  8. Remove the power steering pump and bracket from the vehicle.
  9. If necessary, transfer the power steering pump bracket. Refer to Power Steering Pump Bracket Replacement .
scientia non olet · About LEMON Manuals