LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1107 (Wiper System & Washer System) >> Repair Instructions >> Air Inlet Grille Panel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the hood.
  2. Remove the windshield wiper arms. Refer to Windshield Wiper Arm Replacement .
  3. Remove the rear hood seal from the hem flange on the air inlet grille panel.
    4. Fig 1: View of Air Inlet Panel and Screws
    GM1912987Courtesy of GENERAL MOTORS CORP.
  4. Remove the screws (1) securing the passenger side air inlet panel (2) to the plenum.
  5. Lift the passenger side air inlet grille panel (2) inward in order to disengage the three integral clips from the driver side panel.
  6. Remove the air inlet panel from the vehicle.
    7. Fig 2: View of Driver Side Air Inlet Panel Brace
    GM1912990Courtesy of GENERAL MOTORS CORP.
  7. Remove the nut (1) securing the driver side air inlet panel reinforcement brace to the brake booster stud.
  8. Remove the screw (1) securing the air inlet panel to the fender flange.
  9. Lift the driver side air inlet grille panel (3) over the wiper arm drive spindle and disengage the air inlet panel from the seven windshield frame and plenum panel clips.
  10. Remove the driver side air inlet panel from the vehicle.
scientia non olet · About LEMON Manuals