Headlamp Washer Fluid Pump Test
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the windshield washer fluid pump.
- Test for less than 1 ohm of resistance between the ground circuit terminal B and ground.
- If greater than 1 ohm, repair the ground circuit for an open/high resistance.
- Ignition ON, verify that a test lamp illuminates between the washer pump control circuit terminal A and ground while pressing the washer switch.
- If the test lamp does not illuminate, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, test or replace the underhood fuse block.
- If all the circuits test normal, test or replace the windshield washer fluid pump.