LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1101 (Parking Brake System) >> Repair Instructions >> Parking Brake Rear Cable Replacement - Right Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle and suitably support. Refer to Lifting and Jacking the Vehicle .
  2. Remove the right rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Fig 1: View Of Park Brake Cable
    GM492729Courtesy of GENERAL MOTORS CORP.
  4. Pull down on the intermediate park brake cable (2) near the park brake cable connector (1).
  5. Disconnect the intermediate park brake cable (2) from the park brake connector (1).
  6. Fig 2: Identifying Park Brake Cable And Intermediate Park Brake Cable Connector
    GM751605Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the right rear park brake cable (2) from the intermediate park brake cable connector (3).
  8. Use the J 37043  in order to depress the right rear brake cable retainer. See Special Tools .
  9. Remove the right rear park brake cable (2) from the right rear park brake cable bracket (1).
  10. Fig 3: View Of Left Rear Park Brake Cable, Support Bracket & Actuator Lever
    GM751609Courtesy of GENERAL MOTORS CORP.
  11. Use the J 37043  in order to depress the right rear brake cable retainer. See Special Tools .
  12. Remove the right rear park brake cable from the right rear cable bracket (1).
  13. Disconnect the right rear park brake cable (2) from the right rear park brake actuator lever (3).
  14. Remove the right rear park brake rear cable (2).