LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1101 (Parking Brake System) >> Repair Instructions >> Parking Brake Intermediate Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the park brake.
    2. Fig 1: Identifying Intermediate Cable
    GM1970039Courtesy of GENERAL MOTORS CORP.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Pull down on the intermediate park brake cable and release the connector (1) from the front park brake cable.
    4. Fig 2: View Of Intermediate Park Brake Cable Housing & Locking Retainer
    GM751480Courtesy of GENERAL MOTORS CORP.
  4. Using the J 37043  , depress the locking retainer (2) of the intermediate park brake cable housing (1). See Special Tools .
  5. Remove the intermediate park brake cable from the floor panel bracket (3).
    6. Fig 3: View Of Park Brake Cable Guides
    GM784153Courtesy of GENERAL MOTORS CORP.
  6. Remove the park brake cable guide nut (3) from the mounting stud.
  7. Remove the park brake cable guide bolt (1) from the floor panel.
  8. Remove the park cable guides (2).
    9. Fig 4: View Of Rear Park Brake Cable Connector & Intermediate Park Brake Cable
    GM751494Courtesy of GENERAL MOTORS CORP.
  9. Disconnect the intermediate cable (2) from the rear equalizer (3).
  10. Disconnect the intermediate cable from the right rear park brake cable connector (1).
  11. Disconnect the intermediate cable housing from the rear cable housing retaining bracket by depressing the locking retainer.
  12. Remove the intermediate cable from the vehicle.
scientia non olet · About LEMON Manuals