LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1089 (Lighting Systems) >> Diagnostic Information and Procedures >> Stop Lamps Malfunction >> Circuit/System Testing >> Brake Pedal Position Sensor (BPPS) Malfunction

Brake Pedal Position Sensor (BPPS) Malfunction

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the BPPS.
  2. Ignition ON, verify that a test lamp does not illuminate between the low reference circuit terminal A and ground.
    • If the test lamp illuminates, test the low reference circuit for a short to voltage. If the circuit tests normal, replace the BCM.
  3. Ignition ON, test for 4.8 volts and 5.2 volts between the 5-volt reference circuit terminal C and ground.
    • If less than the specified range, test the 5-volt reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
    • If greater than the specified range, test the 5-volt reference circuit for a short to voltage. If the circuit tests normal, replace the BCM.
  4. If all circuits test normal, replace the BPPS.
scientia non olet · About LEMON Manuals