Rear Bumper Impact Bar Replacement

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Rear Bumper Impact Bar Assembly

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the bumper fascia. Refer to Rear Bumper Fascia Replacement .
1	Rear Bumper Impact Bar Bolt (Qty: 8) NOTE: Refer to Fastener Notice . Tighten: 50 N.m (37 lb ft)
2	Rear Bumper Impact Bar Procedure Unclip the electrical harness from the impact bar. Transfer the necessary components.

Callout

Component Name

Preliminary Procedure:
Remove the bumper fascia. Refer to Rear Bumper Fascia Replacement .

Rear Bumper Impact Bar Bolt (Qty: 8)

NOTE: Refer to Fastener Notice .

Tighten: 50 N.m (37 lb ft)

Rear Bumper Impact Bar

Procedure

Unclip the electrical harness from the impact bar.
Transfer the necessary components.