LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1073 (Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, Or 7.0L (3 Of 5)) >> Off-Vehicle Repair Information (1 Of 3) >> Oil Pump, Screen and Crankshaft Oil Deflector Removal (RPO LY6/L76/L92)

Oil Pump, Screen and Crankshaft Oil Deflector Removal (RPO LY6/L76/L92)

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pump Screen, Bolt, Nuts, & O-Ring Seal
    GM1277115Courtesy of GENERAL MOTORS CORP.
  1. Remove the oil pump screen bolt (405) and nuts (404).
  2. Remove the oil pump screen (407) with O-ring seal (406).
  3. Remove the O-ring seal from the pump screen.
  4. Discard the O-ring seal.
    5. Fig 2: View Of Crankshaft Oil Deflector
    GM260099Courtesy of GENERAL MOTORS CORP.
  5. Remove the remaining crankshaft oil deflector nuts.
  6. Remove the crankshaft oil deflector.
    7. Fig 3: View Of Oil Pump & Bolts
    GM1658173Courtesy of GENERAL MOTORS CORP.
  7. Remove the oil pump bolts (411).
    8. IMPORTANT: Do not allow dirt or debris to enter the oil pump assembly. Cap ends, as necessary.
  8. Remove the oil pump (413).
scientia non olet · About LEMON Manuals