Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra and 2008 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to ENGINE MOUNTING NOTICE .

Fig 1: Engine Mount To Engine Mount Bracket & Bolts

GM310259

Courtesy of GENERAL MOTORS CORP.

From under the hood, remove the engine mount to engine mount bracket bolts. (right side shown, left side similar).

Fig 2: Identifying Oil Pan Skid Plate

GM309158

Courtesy of GENERAL MOTORS CORP.

Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
Remove the oil pan skid plate bolts and plate.

NOTE: Refer to ENGINE LIFTING NOTICE .

Fig 3: View Of Square Tab At Rear Of Engine Block

GM374320

Courtesy of GENERAL MOTORS CORP.

Using an adjustable jack on the square tab at the rear of the engine block, raise the engine.

Fig 4: Engine Mount Bolts

GM310267

Courtesy of GENERAL MOTORS CORP.

Remove the engine mount bolts. (right side shown, left side similar).
Remove the engine mount.

Fig 5: Engine Mount Side Bracket & Bolts

GM310262

Courtesy of GENERAL MOTORS CORP.

If equipped and necessary, remove the engine mount side bracket bolts and bracket. (right side shown, left side similar).

Fig 6: Engine Mount Bracket & Bolts

GM781984

Courtesy of GENERAL MOTORS CORP.

Remove the engine mount bracket bolts.
Remove the engine mount bracket.