LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1063 (Front Drive Axle) >> Repair Instructions >> Vent Hose Replacement (9.25 Inch Axle) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Vent Hose & Wiring Bundle
    GM341716Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the engine shield, if equipped. Refer to Engine Shield Replacement .
    3. IMPORTANT: Make note of the routing in order to aid in reassembly.
  3. Remove the vent hose (1) from the wiring bundle (2), S4WD axles only.
  4. Remove the vent hose from the retainer clips, all axles.
    5. Fig 2: View Of Vent Hose To Differential Carrier Assembly
    GM834272Courtesy of GENERAL MOTORS CORP.
  5. Remove the vent hose from the differential carrier assembly.
  6. Remove the vent hose from the vehicle.
scientia non olet · About LEMON Manuals