LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1028 (Engine Controls And Fuel - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of MAP Sensor, Bracket & Bolt
    GM1871204Courtesy of GENERAL MOTORS CORP.
  1. Install the MAP sensor and bracket.
    2. NOTE: Refer to Fastener Notice .
  2. Install the MAP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    3. Fig 2: View Of Intake Air Heater (IAH) & Manifold Absolute Pressure (MAP) Sensor Electrical Connectors
    GM1871195Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine wiring harness electrical connector (2) to the MAP sensor.
scientia non olet · About LEMON Manuals