LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1028 (Engine Controls And Fuel - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Intake Air Temperature (IAT) Sensor 2 Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of IAT Sensor & Electrical Connector
    GM1602068Courtesy of GENERAL MOTORS CORP.
  1. Remove the air intake pipe. Refer to Air Intake Pipe Replacement .
  2. Disconnect the engine wiring harness electrical connector (1) from the intake air temperature (IAT) sensor pigtail.
  3. Remove the IAT sensor (2) from the center intake manifold.
scientia non olet · About LEMON Manuals