LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1028 (Engine Controls And Fuel - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Rail Fuel Feed Pipe Replacement - Right Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Feed Pipe Fittings & Clamp Bolts
    GM1872372Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel feed pipe. Refer to Fuel Feed Pipe Replacement .
  2. Remove the exhaust gas recirculation (EGR) valve cooler. Refer to Exhaust Gas Recirculation Valve Cooler Replacement .
    3. IMPORTANT: Engine wiring harness shown removed for clarity.
  3. Remove the fuel rail fuel feed pipe clamp bolts (2 and 3) and upper clamps.
  4. Loosen the fuel rail fuel feed pipe fitting (1) at the left fuel rail.
  5. Loosen the fuel rail fuel feed pipe fitting (4) at the right fuel rail.
    6. Fig 2: View Of Right Fuel Rail Fuel Feed Pipe
    GM1872374Courtesy of GENERAL MOTORS CORP.
  6. Remove the right fuel rail fuel feed pipe.
scientia non olet · About LEMON Manuals