Installation Procedure
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the fuel cooler (1).
- Install the fuel cooler nuts (2).
Tighten: Tighten the nuts to 40 N.m (30 lb ft).
- Connect the fuel lines at the fuel cooler (1). Refer to Metal Collar Quick Connect Fitting Service .
- Lower the vehicle.
- Prime the fuel system. Refer to Fuel System Priming .
- Start the engine. If the engine stalls, repeat the above step.
- Once the engine starts, inspect for fuel leaks.
NOTE:
Refer to Fastener Notice