LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1028 (Engine Controls And Fuel - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Engine Coolant Temperature Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.
    Fig 1: View Of Engine Coolant Temperature Sensor Connectors
    GM1870783Courtesy of GENERAL MOTORS CORP.
  1. Drain the cooling system to a level below the engine coolant temperature (ECT) sensors. Refer to Cooling System Draining and Filling (Vac-N-Fill) or Cooling System Draining and Filling (Static Fill) .
  2. Disconnect the engine wiring harness electrical connector (1) from the appropriate ECT sensor.
    3. Fig 2: View Of Engine Coolant Temperature Sensors
    GM1870784Courtesy of GENERAL MOTORS CORP.
  3. Remove the appropriate ECT sensor (1).
scientia non olet · About LEMON Manuals