LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1028 (Engine Controls And Fuel - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Engine Control Module Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying ECM Electrical Connectors
    GM1612203Courtesy of GENERAL MOTORS CORP.
  1. Using a scan tool, capture the ECM data.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (w/Single Battery) or Battery Negative Cable Disconnection and Connection (w/Auxiliary Battery) or Battery Negative Cable Disconnection and Connection (w/Dual Batteries) .
  3. Disconnect the ECM electrical connectors (2).
    4. Fig 2: Identifying ECM Retaining Tabs
    GM1603136Courtesy of GENERAL MOTORS CORP.
  4. Release the ECM upper retaining tabs.
  5. Remove the ECM from the bracket.
scientia non olet · About LEMON Manuals