LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1027 (Engine Controls And Fuel - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Heated Oxygen Sensor Replacement - Bank 2 Sensor 2 >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra and 2008 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to HEATED OXYGEN AND OXYGEN SENSOR NOTICE .
    Fig 1: View Of Engine Harness Clip & Electrical Connectors
    GM1876457Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the connector position assurance (CPA) retainer.
  3. Disconnect the engine wiring harness electrical connector (2) from the HO2S pigtail electrical connector (1).
  4. Remove the HO2S pigtail electrical connector clip from the engine wiring harness clip (3).
    5. Fig 2: View Of HO2S
    GM1876458Courtesy of GENERAL MOTORS CORP.
  5. Remove the HO2S (3).
scientia non olet · About LEMON Manuals