LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1027 (Engine Controls And Fuel - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Level Sensor Replacement (Extended Cab w/26 Gal Tank) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra and 2008 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Level Sensor
    GM1854697Courtesy of GENERAL MOTORS CORP.
  1. Position the fuel level sensor over the slot in the reservoir and slide the sensor down into the slot.
    2. Fig 2: Sensor Clip & Retainers
    GM1854696Courtesy of GENERAL MOTORS CORP.
  2. Ensure that the fuel level sensor retainers (1) engage the module reservoir.
  3. Install the fuel level sensor wiring pigtail under the module clip (2).
    4. Fig 3: Fuel Level Sensor Electrical Connectors
    GM1854694Courtesy of GENERAL MOTORS CORP.
  4. Connect the fuel level sensor wiring pigtail electrical connector (1) to the module cover.
  5. Install the fuel tank module. Refer to Fuel Sender Assembly Replacement (Regular Cab w/34 Gal Tank)  or Fuel Sender Assembly Replacement (Regular Cab w/26 Gal Tank)  or Fuel Sender Assembly Replacement (Extended Cab w/26 Gal Tank) .
scientia non olet · About LEMON Manuals