LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1013 (Engine Controls And Fuel - 4.8L, 5.3L, 6.0L, 6.2L, Or 7.0L - Troubleshooting & Diagnosis) >> Fuel System Diagnosis (w/o FPCM) >> Circuit/System Description >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT:
    • Inspect the fuel system for damage or external leaks before proceeding.
    • Verify that adequate fuel is in the fuel tank before proceeding.
    • The fuel pump relay may need to be commanded ON a few times in order to obtain the highest possible fuel pressure.
  1. Ignition ON, command the fuel pump relay ON with a scan tool. You should hear the fuel pump turn ON and OFF.
  2. Ignition OFF, all accessories OFF, install the CH-48027  . See Special Tools . Refer to Fuel Pressure Gage Installation and Removal .
  3. Ignition ON, command the fuel pump relay ON with a scan tool. Verify the fuel pressure is between 345-414 kPa (50-60 psi) and remains steady for 5 minutes.
scientia non olet · About LEMON Manuals