Removal Procedure
- Disengage the energy storage box (ESB) service disconnect/connect. Refer to Energy Storage Box (ESB) Service Disconnect/Connect (5.3L Engine w/RPO HP2) in Engine Electrical.
- Remove the air conditioning (A/C) drive belt. Refer to Drive Belt Replacement - Air Conditioning .
- Remove the fan shroud - lower. Refer to Fan Shroud Replacement - Lower in Engine Cooling.
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the passenger side closeout bolt and closeout.
- Install the J 46093
(1) and bolts. See Special Tools
.
The flange on J 46093 should locate into the hole in the flexplate. See Special Tools . Use 2 M10 1.5 x 40 mm bolts for proper tool operation.
Tighten: Tighten the bolts to 50 N.m (37 lb ft).
- Remove the crankshaft balancer bolt.
Do not discard the crankshaft balancer bolt. The balancer bolt will be used during the balancer installation procedure.
- Use the J 41816 and J 41816-2 in order to remove the crankshaft balancer. See Special Tools .
- Remove the J 41816 and the J 41816-2 from the crankshaft balancer. See Special Tools .
- Clean and inspect the crankshaft balancer. Refer to Crankshaft Balancer Cleaning and Inspection .
NOTE:
Refer to Fastener Notice
in Cautions and Notices.