LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Steering Column Switches >> Steering Wheel & Steering Column >> Repair Instructions >> Steering Wheel Replacement >> Installation Procedure

Installation Procedure

  1. Align the marks made during the removal of the steering shaft and the steering wheel.
  2. Install the steering wheel onto the steering shaft.
    Fig 1: Installing Steering Wheel Onto Steering Shaft
    GM245807Courtesy of GENERAL MOTORS CORP.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the steering wheel nut to the steering shaft.

    Tighten:  Tighten the nut to 40 N.m (29 lb ft).

  4. Install the horn switch. Refer to Horn Switch Replacement .
  5. Install the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
  6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
scientia non olet · About LEMON Manuals