LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Steering Column Switches >> Steering Wheel & Steering Column >> Repair Instructions >> Steering Wheel Control Switch Assembly Replacement >> Removal Procedure

Removal Procedure

  1. Remove the steering wheel. Refer to Steering Wheel Replacement .
  2. Remove the shroud retaining screws from the back of the steering wheel.
    Fig 1: View Of Shroud & Screws
    GM755486Courtesy of GENERAL MOTORS CORP.
  3. Remove the shroud from the steering wheel.
  4. Position a blunt ended tool into the wire harness cavity (1) and apply moderate pressure in order to partially remove the steering wheel control switch from the steering wheel.
    Fig 2: Using Blunt Ended Tool To Release Steering Wheel Control Switch
    GM755485Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the steering wheel control switch electrical connector.
    Fig 3: View Of Steering Wheel Control Switch Electrical Connector
    GM652807Courtesy of GENERAL MOTORS CORP.
    6. IMPORTANT: The bulbs in the steering wheel control switches are not serviceable. The switches should be replaced only as an assembly.
  6. Remove the steering wheel control switch from the steering wheel.
scientia non olet · About LEMON Manuals