LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Steering Column Switches >> Steering Wheel & Steering Column >> Repair Instructions >> Steering Column Seal Replacement >> Installation Procedure

Installation Procedure

  1. Install the seal to the vehicle.
    Fig 1: Installing Steering Column Seal
    GM362507Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nuts to the studs.

    Tighten:  Tighten the nuts to 3 N.m (27 lb in).

  3. Install the intermediate shaft. Refer to Intermediate Steering Shaft Replacement - Lower .
scientia non olet · About LEMON Manuals