LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Steering Column Switches >> Steering Wheel & Steering Column >> Repair Instructions >> Shift Lever Replacement (With Tow/Haul Switch) >> Installation Procedure

Installation Procedure

  1. Install the shift lever (1).
    Fig 1: Installing Shift Lever
    GM362445Courtesy of GENERAL MOTORS CORP.
  2. Connect the shifter electrical connector.
  3. Install the wire straps to the harness.
  4. Install the harness retaining pin (4) to the instrument panel.
    Fig 2: Installing Wiring Harness Retaining Pin To Instrument Panel
    GM748881Courtesy of GENERAL MOTORS CORP.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 3: Installing Knee Bolster Deflector Bracket
    GM748879Courtesy of GENERAL MOTORS CORP.
  5. Install the knee bolster deflector bracket and nuts (1).

    Tighten:  Tighten the nuts to 9 N.m (80 lb in).

  6. Install the knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gages and Console.
  7. Install the TORX® head shift lever screw.

    Tighten:  Tighten the screw to 20 N.m (15 lb ft).

  8. Roll the seal over the TORX® head shift lever screw.
  9. Install the 2 TORX® head screws to the lower column trim cover.
  10. Install the trim covers. Refer to Steering Column Trim Covers Replacement .
scientia non olet · About LEMON Manuals