LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Optra5 LT, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Stop Lamp Switch Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Stop Lamp Switch Connector
    GM1289935Courtesy of GENERAL MOTORS CORP.
  1. Place the stop lamp switch into the plug connector.
  2. Twist the stop lamp switch into the brake pedal bracket hole.
  3. Depress the brake pedal and pull the switch plunger to its maximum setting to adjust the switch.
  4. Release the plunger and pull up on the pedal.
  5. Connect the negative battery cable.
scientia non olet · About LEMON Manuals