Instrument Panel (I/P) Trim Plate Replacement - (Impala)

Fig 1: Replacing Instrument Panel (I/P) Trim Plate

Courtesy of GENERAL MOTORS CORP.

Trim Plate Replacement - Instrument Panel (I/P) (Impala)

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .Preliminary Procedure: Remove the instrument panel outer trim covers. Refer to Instrument Panel (I/P) Outer Trim Cover Replacement - Left and Instrument Panel (I/P) Outer Trim Cover Replacement - Right .
1	Screw, Instrument Panel Trim Plate (Qty: 4) Tighten: 2 N.m (18 lb in)
2	Plate Assembly, Instrument Panel Trim Tip: Disconnect the electrical connector. Tilt the steering column to the lowest position. Remove the driver information center switch. Refer to Driver Information Center Switch Replacement (Impala) or Driver Information Center Switch Replacement (Monte Carlo) .
3	Clip, Retainer (Qty: 8)