Digital Radio Receiver Replacement

Fig 1: Replacing Digital Radio Receiver

Courtesy of GENERAL MOTORS CORP.

Receiver Replacement - Digital Radio

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . IMPORTANT: Do not swap digital radio receivers between vehicles. Swapping digital receivers between vehicles will activate the digital radio Theftlock. "XM Theftlock" will be displayed. Preliminary Procedure Remove the right rear compartment trim. Refer to Compartment Side Trim Replacement - RH Rear . After replacement, perform the digital radio setup procedure. Refer to Digital Radio Receiver Setup . Program the digital radio receiver after replacement. Refer to Control Module References .
1	Nuts, Digital Radio Receiver Bracket (Qty: 2) Tip: Disconnect the antenna and electrical connectors from the module. Tighten: 3.5 N.m (31 lb in)
2	Receiver Assembly, Digital Radio

Callout

Component Name

NOTE: Refer to Fastener Notice .

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

IMPORTANT: Do not swap digital radio receivers between vehicles. Swapping digital receivers between vehicles will activate the digital radio Theftlock. "XM Theftlock" will be displayed.

Preliminary Procedure

Remove the right rear compartment trim. Refer to Compartment Side Trim Replacement - RH Rear .
After replacement, perform the digital radio setup procedure. Refer to Digital Radio Receiver Setup .
Program the digital radio receiver after replacement. Refer to Control Module References .

Nuts, Digital Radio Receiver Bracket (Qty: 2)
Tip: Disconnect the antenna and electrical connectors from the module.

Tighten: 3.5 N.m (31 lb in)

Receiver Assembly, Digital Radio