Brake Shoes &/Or Pads: Remove & Replace

Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.

Applies To	Note	Standard Hours	Warranty Hours	Skill Level
All		1.8		B
Front,Both Sides		1.0		B
Rear,Both Sides		1.0		B
Combination Procedure: BRAKE HOSE: Replace:
4-Wheel ABS, One	Includes: Perform ABS Automated Bleed procedure.	0.8		B
Power-Assist (Non-ABS), One	Includes: Bleed Brakes.	0.4		B
Each Additional		0.2		B
Combination Procedure: CALIPER: Overhaul:
4-Wheel ABS, Front,One	Includes: Perform ABS Automated Bleed procedure.	1.1		B
4-Wheel ABS, Rear,One	Includes: Perform ABS Automated Bleed procedure.	0.9		B
Power-Assist (Non-ABS), Front,One	Includes: Bleed Brakes.	0.7		B
Power-Assist (Non-ABS), Rear,One	Includes: Bleed Brakes.	0.5		B
Combination Procedure: CALIPER: Replace:
4-Wheel ABS, One	Includes: Perform ABS Automated Bleed procedure.	0.7		B
Power-Assist (Non-ABS), One	Includes: Bleed Brakes.	0.3		B
Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle:
		0.5		B
Combination Procedure: DISC ROTOR: Correct:
Lateral Runout,Each	Correct Rotor lateral runout by indexing or correction plate.	0.2		B
Combination Procedure: DISC ROTOR (REMOVED): Refinish: DOES NOT include grind hot spots.
Each Additional		0.3		B
One		0.5		B
Combination Procedure: HUB & ROTOR DISC: Clean & Inspect:
Corrosion,Each	Clean any rust or corrosion from mating surface of Hub/Axle Flange and Brake Rotor.	0.2		B
Combination Procedure: PARKING BRAKE SHOE & LINING: Replace:
Each Side		0.2		B
Combination Procedure: WHEEL BEARING: Replace:
Front,One Side		0.4		B
Rear,One Side		0.5		B