Wheel Bearing/Hub Replacement - Rear

Fig 1: Wheel Bearing/Hub Replacement - Rear

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the wheel. Refer to Tire and Wheel Removal and Installation . Remove the rear brake drum. Refer to Brake Drum Replacement .
1	Rear Wheel Bearing/Hub Nuts (Qty: 4) Tip: Disconnect the electrical connector from the wheel bearing/hub, if equipped. Tighten: 45 N.m (33 lb in) plus 30° rotation.
2	Rear Wheel Bearing/Hub Tip: Pull the wheel bearing/hub from the axle.

Callout

Component Name

NOTE: Refer to Fastener Notice .

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedures

Rear Wheel Bearing/Hub Nuts (Qty: 4)
Tip: Disconnect the electrical connector from the wheel bearing/hub, if equipped.

Tighten: 45 N.m (33 lb in) plus 30° rotation.

Rear Wheel Bearing/Hub
Tip: Pull the wheel bearing/hub from the axle.