Inflatable Restraint Sensing and Diagnostic Module Replacement

Fig 1: Inflatable Restraint Sensing and Diagnostic Module Replacement

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling and Enabling Zones. Failure to observe the correct procedure could cause deployment of the SIR components, personal injury, or unnecessary SIR system repairs. CAUTION: Do not strike or jolt the inflatable restraint sensing and diagnostic module (SDM). Before applying power to the SDM, make sure that it is securely fastened with the arrow facing toward the front of the vehicle. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs. NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedure Disable the SIR. Refer to SIR Disabling and Enabling Zone 8 . Remove the center console. Refer to Console Replacement .
1	Nut, Inflatable Restraint Sensing and Diagnostic Module (Qty: 3) Tighten: 10 N.m (89 lb in)
2	Module, Inflatable Restraint Sensing and Diagnostic Tip: Reprogram the Inflatable Restraint Sensing and Diagnostic Module after installation. Refer to Control Module References .

Callout

Component Name

CAUTION: When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling and Enabling Zones. Failure to observe the correct procedure could cause deployment of the SIR components, personal injury, or unnecessary SIR system repairs.

CAUTION: Do not strike or jolt the inflatable restraint sensing and diagnostic module (SDM). Before applying power to the SDM, make sure that it is securely fastened with the arrow facing toward the front of the vehicle. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.

NOTE: Refer to Fastener Notice .

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedure

Disable the SIR. Refer to SIR Disabling and Enabling Zone 8 .
Remove the center console. Refer to Console Replacement .

Nut, Inflatable Restraint Sensing and Diagnostic Module (Qty: 3)

Tighten: 10 N.m (89 lb in)

Module, Inflatable Restraint Sensing and Diagnostic
Tip: Reprogram the Inflatable Restraint Sensing and Diagnostic Module after installation. Refer to Control Module References .