Inflatable Restraint Passenger Presence System Replacement - Front

Fig 1: Inflatable Restraint Passenger Presence System Replacement - Front

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. All the components in the service kit are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly. Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedure Remove the front seat. Refer to Seat Replacement - Front Bucket . Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Passenger Presence System Programming and Setup .
1	Pad, Passenger Seat Cushion Cover Refer to Seat Cushion Cover and Pad Replacement - Front .
2	Retainer, Inflatable Restraint Front Passenger Presence Sensor (Qty: 2)
3	Sensor, Inflatable Restraint Front Passenger Presence Tip: Disconnect the electrical connector. The passenger presence system is an integral part of the pad on the passenger seat cushion. The sensor, module and seat cushion pad must be replaced as a unit.
4	Rivet, Inflatable Restraint Front Passenger Presence Module (Qty: 2) Tip: Drill out the rivets to remove.
5	Module, Inflatable Restraint Front Passenger Presence Tip: The sensor, module and seat cushion pad must be replaced as a unit.