Fastener Tightening Specifications
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| A/C Refrigerant Pressure Sensor | 5 N.m | 44 lb in |
| Blower Motor Mounting Screws | 1.8 N.m | 16 lb in |
| Blower Motor Nuts | 2.4 N.m | 21 lb in |
| Blower Resister Mounting Screws | 1.8 N.m | 16 lb in |
| Center Air Distribution Duct Retaining Screws | 2.5 N.m | 22 lb in |
| Compressor Clutch Drive Plate Bolt | 12 N.m | 106 lb in |
| Compressor Drain Plug | 16 N.m | 12 lb ft |
| Compressor Hose to Compressor Bolt | 20 N.m | 15 lb ft |
| Compressor Hose to Condenser Bolt | 20 N.m | 15 lb ft |
| Compressor Hose to Evaporator Hose Nut | 20 N.m | 15 lb ft |
| Compressor Mounting Bolts | 25 N.m | 18 lb ft |
| Compressor Pressure Relief Valve | 7 N.m | 62 lb in |
| Condenser Mounting Bolts | 20 N.m | 15 lb ft |
| Defroster Duct Retaining Screws | 2.5 N.m | 22 lb in |
| Evaporator Inlet Line Clamp Nut | 10 N.m | 88 lb in |
| Evaporator Inlet Line to Condenser Bolt | 20 N.m | 15 lb ft |
| Evaporator Outlet Line to TXV Nut | 20 N.m | 15 lb ft |
| Heater Core Cover Screws | 1.8 N.m | 16 lb in |
| HVAC Module Actuator Screws | 1.8 N.m | 16 lb in |
| HVAC Module Case Screws | 1.8 N.m | 16 lb in |
| HVAC Module to Cross Vehicle Beam Mounting Bolts | 10 N.m | 88 lb in |
| HVAC Module to Dash Panel Nuts | 10 N.m | 88 lb in |
| Instrument Panel (I/P) Carrier Bolts | 25 N.m | 18 lb ft |
| Outer Air Outlet Duct Retaining Screws | 2.5 N.m | 22 lb in |
| Service Port Valve Core | 2.5 N.m | 22 lb in |
| Side Window Duct Retaining Screws | 2.5 N.m | 22 lb in |
| TXV to Evaporator Core Mounting Bolts | 7 N.m | 62 lb in |