Charge Indicator Inoperative

Step	Action	Yes	No
Connector End View Reference: Engine Control Module (ECM) Connector End Views for the 2.2L (L61) engine or Engine Control Module (ECM) Connector End Views for the 2.4L engine
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Turn ON the ignition, with the engine OFF. Does the battery charge indicator illuminate?	Go to Testing for Intermittent Conditions and Poor Connections	Go to Step 3
3	Install a scan tool. With a scan tool, command the lamp and gages ON and OFF. Does the charge indicator turn ON and OFF with each command?	Go to Step 4	Go to Step 7
4	Test the generator turn on signal circuit for a short to ground or open. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition?	Go to Step 8	Go to Step 5
5	Inspect for poor connections at the harness connector of the engine control module (ECM). Refer to Connector Repairs . Did you find and correct the condition?	Go to Step 8	Go to Step 6
6	Replace the ECM. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement?	Go to Step 8	-
7	Replace the instrument panel cluster (IPC). Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement?	Go to Step 8	-
8	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2